Use the procedure below to specify the interval for receiving GPS signals to acquire location information while running.

1.Enter the Timekeeping Mode.

Navigating Between Modes

2.Press (C).

This displays the GPS signal receive start screen.

3.Press (A) or (D).

This displays the Training Mode screen.

4.Hold down (A) for at least two seconds.

This displays the Training Mode setting screen.

5.Use (A) and (D) to move the pointer to [GPS].

6.Press (C).

7.Use (A) and (D) to move the pointer to [USING GPS].

8.Press (C).

9.Use (A) and (D) to move the pointer to [ON] (enabled) or [OFF] (disabled).

10.Press (C).

After the setting operation is complete, [SETTING COMPLETED] will appear for a few seconds, and then the GPS setting screen will re-appear.

11.Use (A) and (D) to move the pointer to [INTERVAL].

This option is for specifying the location information acquisition interval by GPS signal reception.

12.Press (C).

13.Use (A) and (D) to select a GPS receive interval.

[NORMAL]	Acquires location info every second.
[LONG]	Acquires location info every minute.

14.Press (C) to complete the setting operation.

After the setting operation is complete, [SETTING COMPLETED] will appear for a few seconds, and then the GPS setting screen will re-appear.

15.Press (E) twice to exit the setting screen.