You can use G-SHOCK MOVE to specify alert intervals to keep you informed of your calories burned, elapsed time, and attained altitude while training. Then the watch will perform a sound and/or vibration alert operation whenever you reach an alert interval value while training. Use watch operations to enable or disable alerts.

1.Enter the Timekeeping Mode.

Navigating Between Modes

2.Press (C).

This displays the GPS signal receive start screen.

3.Press (A) or (D).

This displays the Training Mode screen.

4.Hold down (A) for at least two seconds.

This displays the Training Mode setting screen.

5.Use (A) and (D) to move the pointer to [ALERT].

6.Press (C).

7.Use (A) and (D) to select the item whose setting you want to change.

[CALORIES]	Calories burned
[TIME 1]	Time 1
[TIME 2]	Time 2
[ALTITUDE]	Altitude

8.Press (C).

9.Use (A) and (D) to select an alert setting.

[OFF]	Disabled
[ON (REPEAT)]	Enabled (repeat)
[ON (1 TIME)]	Enabled (one time)

• While [ON (REPEAT)] is selected, an alert operation is performed whenever an alert interval value is reached.

10.Press (C) to complete the setting operation.

After the setting operation is complete, [SETTING COMPLETED] will appear for a few seconds, and then the alert setting screen will re-appear.

• If you want to configure settings for another item, repeat steps 7 through 10.

11.Press (E) twice to exit the setting screen.