Setting Up the Auto Measurement Interval
You can select an auto measurement interval of either five seconds or two minutes.
-
1.Enter the Altimeter Mode.
-
2.Hold down (A) for at least two seconds.
-
This displays the Altimeter Mode setting screen.
-
3.Use (A) and (D) to move the pointer to [INTERVAL].
-
4.Press (C).
-
5.Use (A) and (D) to select an auto measurement interval.
-
[2 MINUTES]
Readings taken every second for the first three minutes, and then every two minutes for about the next 12 hours.
[5 SECONDS]
Readings taken every second for the first three minutes, and then every five seconds for about one hour.
-
6.Press (C) to complete the setting operation.
-
After the setting operation is complete, [SETTING COMPLETED] will appear for a few seconds, and then the Altimeter Mode setting screen will re-appear.
-
7.Press (E) to exit the setting screen.