Module No. 3452

Starting Navigation

Holding down the rotary switch for about one second starts a GPS positioning operation. After startup of the positioning operation is complete, icon_3452_GPS_log1 and then the navigation screen will appear.

Note

You can also perform the steps below to display the navigation screen.

Num_circle_1 Press the rotary switch.

This displays the GPS Navigation Mode setting screen.

Num_circle_2 Rotate the rotary switch to move the pointer to [NAVIGATION].

Num_circle_3 Press the rotary switch.

This starts route recording and navigation.

The message [DATA FULL] will appear when remaining memory capacity is low. Pressing the rotary switch will start navigation, and overwrite the oldest log in memory. If you want to delete a different log or if all logs are protected, press (C) to stop navigation and then delete the desired data.

Editing the Navigation Use History

If memory becomes full or if the allowable continuous measurement time is exceeded while a navigation operation is in progress, navigation will stop and the watch will return to the Timekeeping Mode.

Interpreting GPS Navigation Information

①: Memory usage
②: Actual route
③: Scale
④: Log acquisition status
: Log information being acquired
: Log information not being acquired
⑤: Navigation indicators
: Current location
: Start point
: Destination (Goal)^*
to : Waypoints^*
⑥: Route to destination^*
⑦: Elapsed time

* Displayed only when a destination and waypoints are specified.

Top of page

Print this page