Setting a Registered Point as the Destination
You can use the procedure below to specify a registered point as a destination for a navigation operation. If there is already a destination specified and route navigation is being performed, the operation below can be used to set a new destination and start a new route navigation operation.
-
1.If a navigation operation is in progress, stop it.
-
2.Press the rotary switch.
-
3.Rotate the rotary switch to move the pointer to [SETTING].
-
4.Press the rotary switch.
-
5.Rotate the rotary switch to move the pointer to [GOAL].
-
6.Press the rotary switch.
-
7.Rotate the rotary switch to move the pointer to [POINT RECALL].
-
8.Press the rotary switch.
-
9.Rotate the rotary switch to move the pointer to the point you want to specify as your destination.
-
- Selecting [RESET] deletes the currently specified destination.
-
10.Press the rotary switch.
-
11.Rotate the rotary switch to move the pointer to [YES].
-
12.Press the rotary switch.
-
The message [SETTING COMPLETED] will appear after the destination is set. After a few seconds, the GPS Navigation Mode setting screen will re-appear.
-
13.Rotate the rotary switch to move the pointer to [NAVIGATION].
-
14.Press the rotary switch.
-
This starts navigation.