Timer
The timer counts down from a start time specified by you. The watch performs a sound and/or vibration operation when the end of the countdown is reached.
The watch does not perform a vibration alert while the battery level indicator shows 
. The watch does not perform a beep alert while the battery level indicator is “CHG” or lower.
You can enable the beep and vibration alerts as required.
Setting a Start Time
The start time can be set in 1-second units up to 60 minutes.
To configure timer settings with the CASIO WATCHES phone app
If the watch is paired with a phone, you can also use the CASIO WATCHES phone app to set the timer start time.
To configure timer settings with the watch
EZ Settings
Use this procedure to change the timer start time setting in 30-second increments.
-
Display the current time screen.
-
Use (A) and (D) to select [TIMER].
-
Press (C).
-
Press (A) or (D).
-
Use (A) and (D) to change the timer start time setting.
-
Press (C).
This displays the TIMER screen.
This returns to the EZ setting screen.
Each press of (A) changes the setting by -30 seconds, while (D) changes it by +30 seconds.
This starts the timer operation.
Minute and Seconds Setting
You can use the steps below to change the timer start time setting in one-second increments up to 60 minutes.
-
Display the current time screen.
-
Use (A) and (D) to select [TIMER].
-
Press (C).
-
Hold down (A) for at least two seconds.
-
Use (A) and (D) to change the minutes setting.
-
Press (C).
-
Use (A) and (D) to change the seconds setting.
-
Press (C) to complete the setting operation.
This displays the TIMER screen.
This causes a cursor to appear under the minutes setting.
This moves the cursor to the seconds setting.
To return to the minute setting, press (E).
After the setting operation is complete, a check mark appears for a few seconds, and then the TIMER screen re-appears.
Note
To exit the timer setting operation at any point, press (E).
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.
Using the Timer
-
Display the current time screen.
-
Use (A) and (D) to select [TIMER].
-
Press (C).
-
Use the operations below to perform a timer operation.
-
Press any button to stop the sound and/or vibration operation.
This displays the TIMER screen.
The watch performs a sound and/or vibration operation for 10 seconds when the end of the countdown is reached.
You can reset a paused countdown to its start time, by pressing (E).