MIDI-Related Settings

For more information about MIDI, see “Send/receive MIDI data”.

Turning Local Control on/off

When Local Control is turned off, performance information (MIDI data) is output from the Digital Keyboard, but the Digital Keyboard itself does not produce sound. This setting is for sending MIDI data to external devices only.

  1. Press and hold the FUNCTION button, and press the F{5 key.

    • Do not release the FUNCTION button until step 2.

      Figure
    • Each time you press the F{5 key, the setting toggles between on and off. A notification tone signals which setting you have switched to after you press a key.

    Notification tone

    Setting

    High note plays

    On (default setting)

    Low note plays

    Off

  2. To exit the settings, release the FUNCTION button.

Changing the MIDI out channel

Sets the MIDI channel to be used when sending keyboard performance information from the Digital Keyboard to an external device as MIDI data. Different MIDI out channels can be set for the main part and the layered part.

Set the MIDI out channel from 1 to 16 (default value: 1). The MIDI out channel can also be set to 0 (off) on this Digital Keyboard, so that MIDI data is not sent from a specific part.

Setting the MIDI out channel for the main part

  1. Press and hold the FUNCTION button, and press the F5 key.

    • Do not release the FUNCTION button until step 3.

      Figure
  2. Use the C4 to E5 keys to change the MIDI out channel setting.

    Figure

    To do this:

    Operate as follows:

    Lower the setting by 1

    Press the C{4 (–) key.1

    Raise the setting by 1

    Press the E}4 (+) key.1

    Directly input the value

    Use the C4 (0) to E5 (9) keys to enter a two-digit value.

    For channel 3, press “0-3”; for channel 12, press “1-2”. The setting changes when the second digit is entered. 2

    Restore the default value

    Press the C{4 (–) key and the E}4 (+) key at the same time.

    • Press and hold to change the value continuously.

    • Even if you have only entered one digit, releasing the FUNCTION button will confirm the value already entered (e.g., if you press “5” and release the FUNCTION button, the channel will be set to 5).

  3. To exit the settings, release the FUNCTION button.

Setting the MIDI out channel for the layered part

Press the G5 key instead of the F5 key in step 1 of “Setting the MIDI out channel for the main part”.

Figure

After that, the operation is the same as that for the main part.