Using a Pedal

By connecting a pedal (SP-3 or SP-20, sold separately) to the Digital Keyboard, you can make the sound change when the pedal is pressed. For how to connect, see “Connecting a pedal (sold separately)”.

Switching between pedal functions

By default, this pedal works as a damper pedal, but you can make it function differently.

  1. Press and hold the FUNCTION button, and press the F6 key.

    • Do not release the FUNCTION button until step 2.

      Figure
    • Each press of the F6 key changes the setting in the order shown in the table below. A notification tone signals which setting you have switched to after you press a key.

    Notification tone

    Setting

    Details

    Plays once

    Damper (default setting)

    Press the pedal while you play to make the notes sustain even after the keys are released. On an instrument such as an organ where the tones sustain for as long as the key is pressed, notes will continue to sound while the pedal is pressed.

    Plays twice

    Sostenuto

    Only the note of the key that is being held down at the time the pedal is pressed will sustain until the pedal is released, even if the key is released.

    Plays three times

    Soft

    The notes played while the pedal is pressed are slightly reduced in volume.

    Plays four times

    Metronome

    Pressing the pedal starts/stops the metronome.

  2. To exit the settings, release the FUNCTION button.

Turn off the pedal effect for each part

For the main and layered parts, you can turn off the effect that’s applied to the notes played when the pedal is pressed. This is useful when you want to apply a pedal effect to only one part.

Turning off the effect of the pedal on the main part

  1. Press and hold the FUNCTION button, and press the G6 key.

    • Do not release the FUNCTION button until step 2.

      Figure
    • Each time you press the G6 key, the setting toggles between on and off. A notification tone signals which setting you have switched to after you press a key.

    Notification tone

    Setting

    Details

    High note plays

    On (default setting)

    The pedal effect is applied.

    Low note plays

    Off

    The pedal effect is not applied.

  2. To exit the settings, release the FUNCTION button.

Turning off the pedal effect for the layered part

Press the A6 key instead of the G6 key in step 1 of “Turning off the effect of the pedal on the main part”.

Figure

After that, the operation is the same as that for the main part.