Using Watch Operations to Adjust the Time Setting
If your watch cannot connect with a phone for some reason, you can use watch operations to adjust date and time settings.
Setting a Home City
Use the procedure in this section to select a city to use as your Home City. If you are in an area that observes summer time, you can also enable or disable summer time.
-
1.Enter the Timekeeping Mode.
-
2.Hold down (D) for at least two seconds. Release the button when the name of the currently selected Home City appears on the display.
-
3.Use (A) and (C) to change the Home City.
-
- For details refer to the information below.
-
4.Press (E).
-
5.Use (A) to select a summer time setting.
-
Each press of (A) cycles through available settings in the sequence shown below.
- [AUTO]
The watch switches between standard time and summer time automatically.
- [OFF]
The watch always indicates standard time.
- [ON]
The watch always indicates summer time.
- [AUTO]
-
6.Press (D) twice to exit the setting screen.
Setting the Time/Date
-
1.Enter the Timekeeping Mode.
-
2.Hold down (D) for at least two seconds. Release the button when the name of the currently selected Home City appears on the display.
-
3.Press (D).
-
This causes the seconds to flash.
-
4.Keep pressing (E) until the setting item you want to change is selected.
-
- Each press of (E) moves to the next setting item in the sequence shown below.
-
5.Configure the date and time settings.
-
- To reset the seconds to 00: Press (A). 1 is added to the minutes when the current count is between 30 and 59 seconds.
- Use (C) and (A) to change the other settings.
-
6.Repeat steps 4 and 5 to configure time and date settings.
-
7.Press (D) to exit the setting screen.
Switching between 12-hour and 24-hour Timekeeping
You can specify either 12-hour format or 24-hour format for the time display.
-
1.Enter the Timekeeping Mode.
-
2.Hold down (D) for at least two seconds. Release the button when the name of the currently selected Home City appears on the display.
-
3.Press (E) four times.
-
This causes [12H] or [24H] to flash on the display.
-
4.Press (A) to toggle the setting between [12H] (12-hour timekeeping) or [24H] (24-hour timekeeping).
-
5.Press (D) twice to exit the setting screen.