Depending on the model of the camera being used there may be limitations on shooting. Equipped functions depend on the camera model.

• The displayed shooting area and the image that is actually shot may be different, depending on the camera model or mode being used.

• Certain camera models let you specify the movie quality for Remote Capture.
  If you are using a camera that does not support movie quality setting for Remote Capture, movie quality is STD (640×480).

• “Tracking” cannot be selected for the AF area setting while shooting with Remote Capture.
  If “Tracking” is selected in another mode, selecting Remote Capture will cause the AF area setting to change to “Spot”.

• The Motion Shutter cannot be used while shooting with this function.

• Some camera models let you change the recording mode or drive mode. Available recording modes and drive modes depend on the camera model.

• Depending on your camera model, the settings below can be configured with EXILIM Connect while Program Auto High Speed CS is selected as the recording mode or drive mode. The settings you can configure depend on your camera model.

• When the “Focus” setting is “AF” (Auto Focus) or “Macro”, continuous AF is enabled during Remote Capture and focus is performed in the center of image.

• Certain camera models allow interval recording of snapshots. To start an Interval Shooting operation, select either of the modes below as the EXILIM Connect recording mode or drive mode. The recording mode or drive mode you can select depends on your camera model and camera setup.