You can enable or disable notification receive as required.

1.Enter the Notification Mode.

Navigating Between Modes

2.Press (B).

This displays the notification list.

3.Hold down (A) for at least two seconds.

This displays the Notification Mode setting screen.

4.Use (A) and (C) to move the pointer to [CONFIGURATION].

5.Press (B).

6.Use (A) and (C) to select a notification receive ON/OFF setting.

[ON]	Enables receive and notification cut-in display.
[ON (RUN OFF)]	Disables receive during run timing only.
[OFF]	Disables receive and notification cut-in display.

• Notification cut-in displays the contents of a received notification, regardless of the watch mode.

• After about 30 seconds, the display will return to what it was before the notification cut-in appeared.

7.Press (B) to complete the setting operation.

After the setting operation is complete, [SETTING COMPLETED] will appear for a few seconds, and then the Notification Mode setting screen will re-appear.

8.Press (D) to exit the setting screen.