Practical Application 2: Using the “Cycling”: “When stopped, display the distance travelled thus far.” MOMENT SETTER item

1.phone-s On your Android smartphone, start up CASIO MOMENT SETTER+ app and then tap icon_momentsetter_WSDF10.

2.phone-s Tap “Cycling”.

3.phone-s Scroll the menu downwards, and then tap the checkbox to the left of “When stopped, display the distance travelled thus far.” to select it (icon_SmartPuls_checked).

4.wat-s On the watch, start up the Activity app.

  • Hold down the power button for about two seconds to display a list of apps. Scroll the list until “Activity” is displayed and then tap “Activity”.

5.wat-s If the “Cycling” START screen is not displayed, swipe from right to left until it is.

6.wat-s Tap “START”.

  • This starts measurement and displays the “Cycling” timing screen. It also enables “Cycling” category MOMENT SETTER notifications in accordance with your selection in step 3 above.
  • Any time you stop cycling, the watch will display the distance travelled from the point you started. You can also display a map of your current location by swiping the screen from right to left.

7.wat-s Press the power button to return to the Home Screen (watch face screen).

  • Leaving the Activity app timing screen on the display may cause you to miss MOMENT SETTER notifications. To avoid this, return the watch to the Home Screen at this time.
  • To display the Activity app timing screen again, perform the steps below.
1.

Swipe the touch screen from the bottom to top to display the Activity app card.

2.

Swipe the card from right to left. On the screen that appears, tap icon_fullscreen_WSDF10.

8.wat-s After you are finished cycling, swipe the touch screen showing the ongoing timing operation from right to left. On the screen that appears, tap “STOP”.

  • This stops the “Cycling” measurement operation and also disables the “Cycling” category MOMENT SETTER notifications.