Using Watch Operations to Adjust the Time Setting
If your watch cannot connect with a phone for some reason, you can use watch operations to adjust date and time settings.
Setting the Time/Date
-
1.Enter the Timekeeping Mode.
-
2.Hold down (A) for at least two seconds.
-
Release the button when [SET] stops flashing.
-
3.Use (D) to display the setting you want to change.
-
- Each press of (D) cycles through settings in the sequence shown below.
-
4.Configure the date and time settings.
-
- While the seconds are flashing, pressing (E) will reset them to 00. 1 is added to the minutes when the current seconds count is between 30 and 59 seconds.
- To configure settings other than the seconds, use (E) and (B).
-
5.Repeat steps 3 and 4 to select time and date settings.
-
6.Press (A) twice to complete the setting operation.
Switching between 12-hour and 24-hour Timekeeping
You can specify either 12-hour format or 24-hour format for the time display.
-
1.Enter the Timekeeping Mode.
-
2.Hold down (A) for at least two seconds.
-
Release the button when [SET] stops flashing.
-
3.Press (D) three times so [12H] or [24H] is flashing on the display.
-
-
4.Press (E) to select [12H] (12-hour timekeeping) or [24H] (24-hour timekeeping).
-
5.Press (A) twice to complete the setting operation.
Top of page