The face of the watch can be illuminated for viewing in the dark.

To illuminate the face manually

Press (B) to turn on illumination.

• If illumination is on, it will turn off automatically if one of the notifications below starts to sound.

To illuminate the face when Auto Light is enabled

If Auto Light is enabled, face illumination will turn on automatically whenever the watch is positioned at an angle of 40 degrees or more.

Configuring the Auto Light Setting

Holding down (B) for at least two seconds in the Timekeeping Mode toggles Auto Light between enabled and disabled.

• [LT] is displayed while Auto Light is enabled.

• If you do not disable it manually, Auto Light remains enabled for approximately six hours. After that, it becomes disabled automatically.

Specifying the Illumination Duration

You can select either 1.5 seconds or three seconds as the illumination duration.

1.Enter the Timekeeping Mode.

Navigating Between Modes

2.Hold down (A) for at least two seconds.

Release the button when [SET] stops flashing.

3.Press (D) nine times to display [LT].

4.Press (E) to select an illumination duration.

[1]: 1.5-second illumination

[3]: 3-second illumination

5.Press (A) twice to complete the setting operation.