fx-100MS/fx-570MS/
fx-991MS/
(2nd edition / S-V.P.A.M.)
Before Using the Calculator
Calculation Modes and Calculator Setup
Basic Calculations
- ▶Inputting Expression and Values
- ▶Arithmetic Calculations
- ▶Fraction Calculations
- ▶Percent Calculations
- ▶Degree, Minute, Second (Sexagesimal) Calculations
- ▶Multi-Statements
- ▶Using Engineering Notation
- ▶Using Engineering Symbols
- ▶Calculation History and Replay
- ▶Using Memory Functions
Function Calculations
- ▶Pi (π), Natural Logarithm Base e
- ▶Trigonometric Functions, Inverse Trigonometric Functions
- ▶Hyperbolic Functions, Inverse Hyperbolic Functions
- ▶Angle Unit Conversion
- ▶Exponential Functions, Logarithmic Functions
- ▶Power Functions and Power Root Functions
- ▶Integration Calculations
- ▶Differential Calculations
- ▶Rectangular-Polar Coordinate Conversion
- ▶Factorial (!)
- ▶Random Number (Ran#)
- ▶Permutation (nPr) and Combination (nCr)
- ▶Rounding function (Rnd)
- ▶Using CALC
- ▶Using SOLVE
- ▶Scientific Constants (fx-570MS/fx-991MS only)
- ▶Metric Conversion (fx-570MS/fx-991MS only)
Using Calculation Modes
- ▶Complex Number Calculations (CMPLX)
- ▶Statistical Calculations (SD, REG)
- ▶Base-n Calculations (BASE)
- ▶Equation Calculations (EQN)
- ▶Matrix Calculations (MAT) (fx-570MS/fx-991MS only)
- ▶Vector Calculations (VCT) (fx-570MS/fx-991MS only)
Technical Information
Calculation Mode
Before starting a calculation, you must first enter the correct mode as indicated in the table below.
fx-100MS
When you want to perform this type of operation: | Perform this key operation: |
---|---|
General calculations | (COMP) |
Complex number calculations | (CMPLX) |
Standard deviation | (SD) |
Regression calculations | (REG) |
Calculations involving specific number systems (binary, octal, decimal, hexadecimal) | (BASE) |
Equation solution | (EQN) |
fx-570MS/fx-991MS
When you want to perform this type of operation: | Perform this key operation: |
---|---|
General calculations | (COMP) |
Complex number calculations | (CMPLX) |
Standard deviation | (SD) |
Regression calculations | (REG) |
Calculations involving specific number systems (binary, octal, decimal, hexadecimal) | (BASE) |
Equation solution | (EQN) |
Matrix calculations | (MAT) |
Vector calculations | (VCT) |
Note
The initial default calculation mode is the COMP Mode.
Mode indicators appear in the upper part of the display, except for the BASE indicators, which appear in the exponent part of the display.
Engineering symbols are automatically turned off while the calculator is the BASE Mode.
You cannot make changes to the angle unit or other display format (Disp) settings while the calculator is in the BASE Mode.
The COMP, CMPLX, SD, and REG Modes can be used in combination with the angle unit settings.
Be sure to check the current calculation mode (SD, REG, COMP, CMPLX) and angle unit setting (Deg, Rad, Gra) before beginning a calculation.