Module No. 5602

Using Watch Operations to Adjust the Time Setting

If your watch cannot connect with a phone for some reason, you can use watch operations to adjust date and time settings.

Setting a Home City

Use the procedure in this section to select a city to use as your Home City. If you are in an area that observes summer time, you can also enable or disable summer time.

1.Enter the Timekeeping Mode.

Navigating Between Modes

2.Hold down (E) for at least two seconds. Release the button when the name of the currently selected Home City appears on the display.

5602_fl_SET_HT_caps_comon

3.Use (A) and (C) to change the Home City.

  • For details refer to the information below.
City Table

4.Press (D).

5.Use (C) to change the summer time setting.

Each press of (C) cycles through settings in the sequence shown below.

  • [AUTO]
    The watch switches between standard time and summer time automatically.
  • [OFF]
    The watch always indicates standard time.
  • [ON]
    The watch always indicates summer time.
5602_18_TA

6.Press (E) twice to complete the setting operation.

Setting the Time/Date

1.Enter the Timekeeping Mode.

Navigating Between Modes

2.Hold down (E) for at least two seconds. Release the button when the name of the currently selected Home City appears on the display.

5602_fl_SET_HT_caps_comon

3.Press (E).

This causes the seconds to flash.

4.Use (D) to display the setting you want to change.

  • Each press of (D) cycles through settings in the sequence shown below.
fl_Date_Time_seting_Item_02

5.Configure the date and time settings.

  • While the seconds are flashing, pressing (C) will reset them to 00. 1 is added to the minutes when the current seconds count is between 30 and 59 seconds.
  • For all the other settings, use (C) and (A) to change the flashing setting.

6.Repeat steps 4 and 5 to configure time and date settings.

7.Press (E) to complete the setting operation.

Switching between 12-hour and 24-hour Timekeeping

You can specify either 12-hour format or 24-hour format for the time display.

1.Enter the Timekeeping Mode.

Navigating Between Modes

2.Hold down (E) for at least two seconds. Release the button when the name of the currently selected Home City appears on the display.

5602_fl_SET_HT_caps_comon

3.Press (D) four times.

This causes [12H] or [24H] to flash on the display.

5602_19_TA

4.Press (C) to select [12H] (12-hour timekeeping) or [24H] (24-hour timekeeping).

5602_20_fl_TA

5.Press (E) twice to complete the setting operation.