Module No. 5582

Connecting with a Phone

This section explains how to establish a Bluetooth connection with a phone that is paired with the watch.

  • If the watch is not paired with the phone you want to connect with, refer to the information below and pair them.

1.Move the phone close to (within one meter of) the watch.

2.wat_s Hold down (C) for at least 1.5 seconds until [CNCT] starts to flash.

When a connection is established between the watch and phone, [CNCT] will stop flashing and the second hand will move from [R] to BLE_mark.

  • If connection fails for some reason, [ERR] will appear on the display momentarily and then the watch will return to the mode it was in before you started the connection procedure.