Module No. 5582

Configuring Watch Settings

You can use EDIFICE Connected to specify the amount of time until a Bluetooth connection is automatically terminated, to enable or disable the watch operation tone, and to configure other settings.

1.phone-s Tap the “EDIFICE Connected” icon.

2.wat_s Hold down (C) for at least 1.5 seconds until [CNCT] starts to flash.

When a connection is established between the watch and phone, [CNCT] will stop flashing and the second hand will move from [R] to BLE_mark.

  • If connection fails for some reason, [ERR] will appear on the display momentarily and then the watch will return to the mode it was in before you started the connection procedure.
5582_fl_BLE_conect

3.phone-s Select the setting you want to change and then perform the operation shown on the phone screen.