Checking Today’s Step Count
1. Enter the Timekeeping Mode.
2. Use (B) to display the step count.
Interpreting the Step Count Graph The Step Count Graph shows the number of steps (up to 1,000) you have taken each hour. This lets you easily check your walking pace over the past 10 or 11 hours.
The Step Count Graph is not displayed while the step count is zero.
Graph contents are normally updated at the top of each hour.
Note
The step count can show a value up to 999,999 steps. If the step count exceeds 999,999, the maximum value (999,999) remains on the display.
To prevent miscounts, the displayed count does not increase for about 10 seconds after you start walking. After you have been walking for about 10 seconds, the correct count appears, including the steps you took during the previous 10 seconds.
The step count is reset to zero at midnight each day.
To save power, step counting stops automatically if you take off the watch (no detectable watch movement) and you do not perform any operation for two or three minutes.
The Step Count Graph is updated even when any one of the events below occurs.
When accelerometer operation is stopped to save power
When counting is not possible due to accelerometer error or insufficient power
Top of page