The watch will beep when the alarm time is reached. You can configure up to four standard daily alarms, and one daily alarm with snooze. The hourly time signal causes the watch to beep every hour on the hour.

Snooze causes the alarm to sound up to seven times, at five-minute intervals.

Configuring Alarm Settings

1. Enter the Alarm Mode.

Navigating Between Modes

2. Press (D) to scroll through alarms ([AL1] to [AL4], [SNZ]) until the one you want to configure is displayed.



3. Hold down (A) for at least two seconds. Release the button when the hours digits start to flash.

This is the setting mode. The hands automatically shift out of the way for easy viewing of the display and other indicators.

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.



4. Use (B) and (D) to change the hour setting.

Holding down (B) or (D) scrolls through settings at high speed.

If you are using 12-hour timekeeping, [P] indicates p.m.



5. Press (C).

This causes the minutes digits to flash.



6. Use (B) and (D) to set the minute setting.

7. Press (A) to exit the setting screen.

[ALM] is shown on the display while an alarm is set.

Testing the alarm

In the Alarm Mode, hold down (D) to sound the alarm.

To stop the alarm

Pressing any button while the beeper is sounding stops it.

Snooze causes the alarm to sound up to seven times, at five-minute intervals. To cancel a snooze alarm, turn [SNZ] off.

Enabling the Hourly Time Signal

1. Enter the Alarm Mode.

Navigating Between Modes

2. Use (D) to display the hourly time signal screen ([SIG]).



3. Press (B) to toggle the hourly time signal between enabled and disabled.

[SIG] is displayed while the hourly time signal is enabled.

Turning Off an Alarm or the Hourly Time Signal

To stop an alarm or the hourly time signal from sounding, perform the steps below to turn it off.

To have an alarm or hourly time signal sound again, turn it back on.

Note

Indicators are displayed while any of the alarms or the hourly time signal is turned on.

The applicable indicators are not displayed while all of the alarms are turned off and/or the hourly time signal is turned off.

1. Enter the Alarm Mode.

Navigating Between Modes

2. Use (D) to scroll through the alarm ([AL1] to [AL4], [SNZ]) and hourly time signal ([SIG]) screens until the one you want to turn off is displayed.



3. Press (B) to turn off the displayed alarm or the hourly time signal.

Each press of (B) toggles between on and off.

Turning off all alarms will cause [ALM] (alarm) to disappear from the display, while disabling the hourly time signal causes [SIG] (hourly time signal) to disappear from the display.