Module No. 5512

Configuring Stopwatch Settings

You can specify a target value for comparison with lap times measured in the Stopwatch Mode. You can also enable or disable an alert that sounds when your current lap time matches the target value.

Checking the Difference between a Lap Time and the Target Time
Split Times and Lap Times

Specifying the Target Value Type

You can specify one of the target values described below, which are used to calculate the difference between your target and actual lap time measurements.

FASTEST (Fastest):

Your fastest lap time during the current session is automatically set for this target value. This setting is refreshed each time your achieve a new fastest lap. Resetting the stopwatch to all zeros will also clear this target value.

TARGET (Target):

This is a fixed value that you specify using CASIO WATCH+.

1.phone-s Tap the “CASIO WATCH+” icon.

2.wat_s Hold down the (C) button for about 2 seconds.

  • This causes the second hand to move to 12 o’clock. Keep (C) depressed at this time until the second hand completes one full rotation.
  • The retrograde dial hand will move from “R” to BLE_mark when a connection is established between the watch and phone.
5512_Common_01_02_CheckWat

3.phone-s Perform the operation shown on the phone screen to specify a target value type.

Specifying the TARGET (Target) Value

If you specified TARGET (Target) as the target value type, perform the procedure below to specify the target value.

  • The TARGET (Target) value setting cannot be less than 15 seconds.

1.phone-s Tap the “CASIO WATCH+” icon.

2.wat_s Hold down the (C) button for about 2 seconds.

  • This causes the second hand to move to 12 o’clock. Keep (C) depressed at this time until the second hand completes one full rotation.
  • The retrograde dial hand will move from “R” to BLE_mark when a connection is established between the watch and phone.
5512_Common_01_02_CheckWat

3.phone-s Perform the operation shown on the phone screen to specify the TARGET (Target) value.

Enabling or Disabling Alert Sounds

You can configure a setting so the watch sounds a tone when the lap time reaches the target value during measurement.

1.phone-s Tap the “CASIO WATCH+” icon.

2.wat_s Hold down the (C) button for about 2 seconds.

  • This causes the second hand to move to 12 o’clock. Keep (C) depressed at this time until the second hand completes one full rotation.
  • The retrograde dial hand will move from “R” to BLE_mark when a connection is established between the watch and phone.
5512_Common_01_02_CheckWat

3.phone-s Perform the operation shown on the phone screen to enable or disable the alert sound.