This section explains how to measure lap times in watch memory while watching a race, and check the difference between a lap time and target value. It also shows how you can view lap times with CASIO WATCH+ after the race is over.

Before a race

At this time, you should specify the target value type. If you specify TARGET (Target) as the target value type, you should also specify the TARGET (Target) value.

During a race

During the race, you measure split times. Lap times are also measured internally by the watch.

1. Hold down (A) for about 2 seconds.

This will cause the watch to enter the Calendar Mode.

2. Press (A) once.

This will cause the watch to enter the Stopwatch Mode.

3. Use the operations below to measure elapsed time.

Pressing (D) at the end of each lap will record each lap time in watch memory.

• Lap times are recorded in units of 1/1000 seconds.

• You can also use the mode hand to determine the difference between the lap time measured internally by the watch and the target value.

Checking the Difference between a Lap Time and the Target Time

4. Press (D) to reset the elapsed time to zero.

5. Press (A) twice to return to the Calendar Mode.

After a race

After the race is finished, you can view the measure lap times with CASIO WATCH+.