You can configure a setting so the watch sounds a tone when the lap time reaches the target value during measurement.

1.Pull out the crown to the first click.

This will cause the mode hand to move “T” or “F”.

• Pulling out the crown while a measurement operation is in progress in the stopwatch mode will stop the operation and reset the stopwatch to all zeros.

2.Hold down (B) for about two seconds.

This will toggle alert tone between enabled and disabled.

• Pressing (B) in place of step 2 will cause the second hand to indicate the current setting.

3.Push the crown back in.

4.Press (A) twice to return to the Calendar Mode.