Module No. 3584

Timer

The timer counts down from a start time specified by you. A beeper sounds when the end of the countdown is reached.

The beeper is muted when battery power is low.

img_TMR_2023_2

Setting a Start Time

The countdown start time can be set in 1-second units up to 24 hours.

If a timer countdown operation is in progress, reset the timer to its current start time before performing this operation.

  1. Enter the Timer Mode.

  2. Hold down (A) for at least two seconds.

  3. This causes the hours digits to flash.

    3584_29_TR
  4. Use (B) and (D) to change the timer hours setting.

  5. Holding down (B) or (D) scrolls through settings at high speed.

  6. Press (C).

  7. This causes the minutes digits to flash.

    3584_30_TR
  8. Use (B) and (D) to change the timer minutes setting.

  9. Press (C).

  10. This causes the seconds digits to flash.

    3584_31_TR
  11. Use (B) and (D) to change the seconds setting.

  12. Press (A) to exit the setting screen.

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Setting a start time of [0:00 00] will perform a countdown of 24 hours.

Using the Timer

  1. Enter the Timer Mode.

  2. 3584_32_TR
  3. Use the operations below to perform a timer operation.

  4. fl_tmr_D_btn_sstrstu

    A beeper will sound for 10 seconds to let you know when the end of a countdown is reached.

    To reset a paused countdown to the start time, press (A).

  5. Press any button to stop the tone.

Back

Next