Module No. 3584

Alarm

The watch will beep when the alarm time is reached. You can configure up to four standard daily alarms, and one daily alarm with snooze. The hourly time signal causes the watch to beep every hour on the hour.

Snooze causes the alarm to sound up to seven times, at five-minute intervals.

The alarm sound is muted in the cases described below.

When battery power is low

When watch is at Level 2 power saving

img_ALM_2023_2

Configuring Alarm Settings

  1. Enter the Alarm Mode.

  2. Press (D) to scroll through alarms ([1] to [4], [SNZ]) until the one you want to configure is displayed.

  3. 3584_20_AL
  4. Hold down (A) for at least two seconds.

  5. This causes the hours digits to flash.

    3584_21_AL
  6. Use (B) and (D) to change the hour setting.

  7. Holding down (B) or (D) scrolls through settings at high speed.

    If you are using 12-hour timekeeping, [P] indicates p.m.

    3584_22_AL
  8. Press (C).

  9. This causes the minutes digits to flash.

    3584_23_AL
  10. Use (B) and (D) to set the minute setting.

  11. Press (A) to complete the setting operation.

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Testing the alarm

In the Alarm Mode, hold down (D) to sound the alarm.

To stop the alarm

To stop the alarm after it starts to sound when an alarm time is reached, press any button.

Snooze causes the alarm to sound up to seven times, at five-minute intervals. To cancel a snooze alarm, turn [SNZ] off.

Note

A beeper will sound for 10 seconds to let you know when the alarm time is reached.

The watch will automatically return to the Timekeeping Mode from the Alarm Mode after two or three minutes of non-operation.

Turning the Hourly Time Signal On or Off

  1. Enter the Alarm Mode.

  2. Use (D) to display the hourly time signal screen ([SIG]).

  3. 3584_24_AL
  4. Press (A) to toggle the hourly time signal between enabled and disabled.

  5. icon_SIG_2_black (hourly time signal) is shown on the display while the hourly time signal is enabled.

    3584_25_AL

Stopping an Alarm or the Hourly Time Signal

To stop an alarm or the hourly time signal from sounding, perform the steps below to turn it off.

To have an alarm or hourly time signal sound again, turn it back on.

Note

Indicators are displayed while any of the alarms or the hourly time signal is turned on.

The applicable indicators are not displayed while all of the alarms are turned off and/or the hourly time signal is turned off.

3584_26_AL
  1. Enter the Alarm Mode.

  2. Press (D) to scroll through alarm ([1] to [4], [SNZ]) and hourly time signal ([SIG]) screens until the one you want to configure is displayed.

  3. 3584_27_AL
  4. Press (A) to turn off the displayed alarm or the hourly time signal.

  5. Each press of (A) toggles between ON and OFF.

    Turning off an alarm causes icon_ALM_2_black (alarm) to disappear from the display. Turning off the hourly time signal causes icon_SIG_2_black (hourly time signal) to disappear.

    3584_28_AL

Note

If icon_ALM_2_black (alarm) is still displayed after you turn off an alarm, it means that at least one of the other alarms is still turned on. To turn off all of the alarms, repeat steps 2 and 3 until the icon_ALM_2_black (alarm) indicator is no longer displayed.

Back

Next