Perform figure 8 or two-point calibration whenever you notice the watch’s compass readings are different from those of another compass, or before setting out on a climb or trek.

• Note that accurate compass readings and/or calibration will not be possible in an area where strong magnetism is present.

Figure 8 calibration

1.Enter the Compass Mode.

Navigating Between Modes

2.Hold down (D) for at least two seconds. Release the button when [SET] starts flashing and then appears on the display.

3.Press (C).

Move your arm in a figure 8 pattern as shown in the illustrations below.

• Allow your wrist to twist.

• Keep your arm as far as possible from your body as you move it.

• The symbol will stop flashing on the display while calibration is in progress.

• When calibration is successful, [OK] will appear on the display and the watch will return to the Digital Compass screen. This completes the calibration operation.

2-Point Calibration

1.Enter the Compass Mode.

Navigating Between Modes

2.Hold down (D) for at least two seconds. Release the button when [SET] starts flashing and then appears on the display.

3.Press (E).

This causes [ 1] to appear on the display.

4.While keeping the watch horizontal, press (C).

This starts calibration of the first point, which causes [WAIT] to appear on the display. When calibration is successful, indicators will appear on the display in the following sequence: [OK] [TURN] [180°] [ 2].

5.Rotate the watch 180 degrees, taking care to be as exact as possible.

6.Press (C).

• This starts calibration of the second point, which causes [WAIT] to appear on the display.

• When calibration is successful, [OK] will appear on the display and the watch will return to the Digital Compass screen. This completes the calibration operation.

Auto Calibration

Your watch performs auto bearing calibration.

• When bearing calibration starts, the second hand will move to 12 o’clock, and the digital display contents will flash.