Module No. 3506
Setting Up Alerts
You can use G-SHOCK MOVE to specify alert intervals to keep you informed of your calories burned and elapsed time while training. Then, the watch will perform a sound and/or vibration alert operation whenever an alert interval value is reached while you are training. Use watch operations to enable or disable alerts.
-
Enter the Timekeeping Mode.
-
Press (B).
-
Hold down (A) for at least two seconds.
-
Use (A) and (C) to move the pointer to [ALERT].
-
Press (B).
-
Use (A) and (C) to select the item whose setting you want to change.
-
Press (B).
-
Use (A) and (C) to select an alert setting.
-
Press (B) to complete the setting operation.
-
Press (D) twice to exit the setting screen.
This displays the Training Mode screen.
This displays the Training Mode setting screen.
[CALORIES] |
Calories burned |
[TIME 1] |
Time 1 |
[TIME 2] |
Time 2 |
[OFF] |
Disabled |
[ON (REPEAT)] |
Enabled (repeat) |
[ON (1 TIME)] |
Enabled (one time) |
While [ON (REPEAT)] is selected, an alert operation is performed whenever an alert interval value is reached.
After the setting operation is complete, [SETTING COMPLETED] will appear for a few seconds, and then the alert setting screen will re-appear.
If you want to configure settings for another item, repeat steps 6 through 9.
Important!
To specify the alert interval for each item, use G-SHOCK MOVE. Note that you cannot configure settings using watch operations.
Note
You can also use G-SHOCK MOVE to enable or disable alerts.