Module No. 3486

Configuring Settings for an Interval Timer

  • If a timer countdown operation is in progress, reset the timer to its current start time before performing this operation.
Using the Timer

1.Hold down (A) for at least two seconds. Release the button when the number of auto repeats setting (01 to 20) starts to flash.

3486_35_TMR_comon

2.Use (D) and (E) to specify the number of auto repeats.

3.Press (C).

4.Use (D) and (E) to specify the position of the timer in the sequence.

  • To specify the first position, set [1].
3486_42_TMR

5.Press (C).

This causes the minutes digits of Timer 1 to flash.

6.Use (D) and (E) to change the timer minutes setting.

3486_43_TMR

7.Press (C).

This causes the seconds digits of Timer 1 to flash.

8.Use (D) and (E) to change the timer seconds setting.

3486_44_TMR

9.Press (C) twice.

This returns to the screen in step 4.

10.Repeat steps 4 through 9 as many times as necessary to configure the settings of the other timers.

11.Press (A) to exit the setting screen.