Module No. 5713
Recording Waypoints and Their Altitudes (Mission Log)
Route Log uses CASIO WATCHES GPS to record the waypoints of your routes. At the same time, the watch takes altitude readings every two minutes and stores them in memory, and automatically transfers altitude data to CASIO WATCHES every hour.
-
Tap the “CASIO WATCHES” icon.
-
Enter the Altimeter Mode.
-
Hold down (A) for at least five seconds. Release the button after [LOG] starts to flash, and the second hand moves to .
When a connection between the watch and phone is established, [LOG] will change to [LOG ON].
This indicates that Mission Log is enabled.
To disable Mission Log, hold down (A) again for at least five seconds.
Note
[LOG] is displayed while Mission Log is enabled.
Mission Log becomes disabled automatically 12 hours after it is enabled.
Mission Log remains enabled even if you change to another mode.
The watch has enough memory to hold up to 60 altitude records. Recording data when there are already 60 records in memory will automatically delete the oldest record to make room for the new one.
Data Transfer
After Mission Log is enabled, data transfer starts when the number of altitude records in watch memory reaches 30.
Auto data transfer is performed during the normal state of each mode.
The display cycles as shown below as data is being transferred.
The second hand will point to [RC].
If data transfer fails for some reason, the watch will return to the previous screen with [LOG] flashing.
Note
If auto transfer fails for some reason, the watch will keep trying up to five times at 10-minute intervals. Or data is transferred when a CASIO WATCHES connection is established.