Module No. 5713

Checking the Distance and Bearing to a Location Memory Point (Location Indicator)

The watch acquires current location information from the phone, and then displays the bearing and distance from your current location to the location recorded in Location Memory.

Recording Your Current Location (Location Memory)
5713_87_COMP

Important!

Note that CASIO WATCHES operation is disabled while Location Indicator is in use.

  1. phone-s Tap the “CASIO WATCHES” icon.

  2. wat_s Enter the Compass Mode.

    3. Navigating Between Modes

  3. wat_s Hold down (C) for at least two seconds. Release the button when [INDICATE] starts to flash, and the second hand points to BLE_mark.

    4. When a location information receive operation is successful while the watch is connected with a phone, [INDICATE] will change to [OK].

    After two seconds, the distance from your current location to the recorded location appears on the display, and the bearing hand indicates the bearing to the destination.

    5713_88_fl_COMP

    *1
    [dot_ArrowMark] starts to flash on the display when the bearing hand indication is within 30 degrees of the bearing to the destination.

    *2
    [G] is shown on the display when you are within 80 meters of the destination. [G] will disappear from the display if you move to a distance of 161 meters or more from the destination.

  4. wat_s Check the display distance and the bearing to your destination on the display.

Note

Location Indicator remains enabled for three minutes.

The watch connects with the phone and acquires location information every 10 seconds or each time (C) is pressed, and uses the acquired information to refresh the distance and the bearing up to the point stored in Location Memory.

Location Indicator will become disabled automatically about three minutes after it is enabled. You can also disable it manually by pressing any button besides (C) or (E).

Pressing (C) or (E) while Location Indicator is enabled causes it to remain enabled for three minutes after the button is pressed.

Pressing (C) to update data causes [dot_ArrowMark TRY] to appear on the display and remain displayed until data updating is complete.

[dot_ArrowMark FAIL] will appear on the display in the cases below.

When it has been 30 seconds or more since the last update and location information acquisition fails

When it has been 60 seconds or more since the last update

When data update fails after you press (C)

The display range for the distance to a destination is 0 to 99,999 meters (0 to 327,995 feet). [dot_ArrowMark -----] will be shown for the distance to the destination when it is outside the display range.

[ERR] will appear on the display if connection fails for some reason.

The message [NO-DATA] will appear when there is no data in Location Memory.

[FAILED] arrowR [POSITION] will appear in sequence if the first location information acquisition fails.

[dot_ArrowMark] or [G] will flash on the display if the watch detects abnormal magnetism while Location Indicator is in use.

[dot_ArrowMark ERR] will appear on the display if a direction sensor error occurs while Location Indicator is in use.

Back

Next