Module No. 5686

Using the Schedule Timer

The schedule timer can be linked with the calendar of a paired phone, so the watch can display the remaining time of the currently ongoing scheduled event and/or its ending time.

Important!

The schedule timer becomes disabled if you manually adjust the watch’s time setting. Before using the Schedule Timer, connect the watch with your phone and sync their time settings.

Note

The schedule timer corresponds to the built-in calendar of your phone’s OS and Google calendar.

When a scheduled start time or end time is reached, the watch will beep and display an indication for one or two seconds.
You can enable or disable the beep sound as required.

Up to five scheduled events can be sent from your phone to the watch.

Transferring Scheduled Event

Scheduled events can be transferred from your phone to the watch.

While the watch is connected with your phone, scheduled events are periodically transferred to the watch automatically.

Check the connection

Make sure that the BLE_mark symbol is shown on the watch display when you perform the procedure below. If BLE_mark is not displayed, refer to the information at the link below.

  1. phone-s Tap the “CASIO WATCHES” icon.

  2. phone-s Perform the operation shown on the phone screen to transfer phone scheduled events to the watch.

Displaying an Scheduled Event

  1. wat_s Enter the Timekeeping Mode.

  2. wat_s Press (D).

  3. This causes the display to change from the current time to an event.

    Each press of (B) switches between the information as described below.

    5686_15_fl_MobileLink

    The mode hand indicates the time remaining until the currently ongoing event is complete. The mode hand points to [OVER] when the remaining time exceeds 120 minutes.
    If you do not have scheduled events which will finish within 24 hours, the mode hand points to [00].

    5686_16_MobileLink

    When a scheduled start time or end time is reached, the watch will beep and display an indication for one or two seconds.
    You can enable or disable the beep sound as required.

    When the remaining time of the currently ongoing scheduled event is 10 minutes or less, the watch display shows the remaining time, and counts it down in one-second units.

Back

Next