Module No. 5638

Using Watch Operations to Adjust the Time Setting

If your watch cannot connect with a phone for some reason, you can use watch operations to adjust date and time settings.

Setting a Home City

Use the procedure in this section to select a city to use as your Home City. If you are in an area that observes summer time, you can also configure a summer time setting.

1.Enter the Timekeeping Mode.

2.Hold down (B) for at least two seconds. Release the button when the name of the currently selected Home City appears on the display.

5638_fl_SET_HT_caps

3.Use (A) and (D) to change the Home City.

  • For details refer to the information below.

4.Press (C).

5.Use (D) to select a summer time setting.

Each press of (D) cycles through available settings in the sequence shown below.

  • [AUTO]
    The watch switches between standard time and summer time automatically.
  • [OFF]
    The watch always indicates standard time.
  • [ON]
    The watch always indicates summer time.
5638_DST_Auto_common

6.Press (B) to exit the setting screen.

Setting the Time/Date

1.Enter the Timekeeping Mode.

2.Hold down (B) for at least two seconds. Release the button when the name of the currently selected Home City appears on the display.

5638_fl_SET_HT_caps

3.Keep pressing (C) until the setting you want to change is flashing.

  • Each press of (C) moves the flashing to the next setting in the sequence shown below.
fl_Date_Time_seting_Item_03

4.Configure the date and time settings.

  • To reset the seconds to 00: Press (D). 1 is added to the minutes when the current count is between 30 and 59 seconds.
  • Use (A) and (D) to change the other settings.

5.Repeat steps 3 and 4 to select time and date settings.

6.Press (B) to exit the setting screen.

Switching between 12-hour and 24-hour Timekeeping

You can specify either 12-hour format or 24-hour format for the time display.

1.Enter the Timekeeping Mode.

2.Hold down (B) for at least two seconds. Release the button when the name of the currently selected Home City appears on the display.

5638_fl_SET_HT_caps

3.Press (C) twice.

This causes [12H] or [24H] to flash on the display.

5638_12_ATDS

4.Press (D) to toggle the setting between [12H] (12-hour timekeeping) and [24H] (24-hour timekeeping).

5638_13_fl_ATDS

5.Press (B) to exit the setting screen.