Stopwatch
Starting a Elapsed Time Measurement Operation from the Calendar Mode (Direct Start)

Module No. 5588

Starting a Elapsed Time Measurement Operation from the Calendar Mode (Direct Start)

Direct Start lets you start a stopwatch elapsed time measurement operation from the Calendar Mode, without switching to the Stopwatch Mode first.

1.Press (A) twice in succession.

This starts a stopwatch elapsed time measurement operation.

5588_fl_27_ST

Note

Before using Direct Start, make sure that the stopwatch is reset to all zeros.

If the result of the last elapsed time measurement operation you performed is stopped on the stopwatch display, pressing (A) twice in succession in the Calendar mode will display that result.

If the last stopwatch elapsed time measurement operation you performed is still ongoing, pressing (A) twice in succession in the Calendar mode will display that ongoing operation.

Direct Start is disabled when any one of the conditions below exists.

While the alarm or timer beeper is sounding

While a time signal receive operation is in progress

Bluetooth connection

Print this page