To correct hand and day indicator alignment

1.Pull out the crown to the second click.

2.Hold down the (A) button for at least five seconds. This should cause the second hand and minute hand to move to 12 o’clock.

3.If the second hand and minute hand do not stop at 12 o’clock, rotate the crown to move them there.

You can use the second hand fast forward or fast reverse operation to move the minute hand.

4.Press (A).

Confirm that the hour hand is stopped at 12 o’clock and the date indicator is stopped in between the today’s date and tomorrow’s date.

If the hour hand is misaligned by up to three hours at this time, go to step 5 of this procedure.

If the your hand is misaligned by more than three hours or if the indicated date is wrong, go to step 6 of this procedure.

5.Rotate the crown to align the hour hand with 12 o’clock.

After the hour hand is in the correct position, advance to step 8 of this procedure.

6.Hold down the (A) button for at least 2 seconds.

Confirm that the hour hand is stopped at 12 o’clock (home position) and that the day indicator is stopped between “31” and “1” (home position).

7.If the hour hand and day indicator are not in their home positions, rotate the crown to move them there.

To move the day indicator, used the hour hand fast forward or fast reverse operation.

8.Push the crown back in to its normal position.

After finishing the above operation, configure time and date settings.

If you are using the watch in Japan or another location where time calibration signal reception is possible
Auto Time Adjustment

If you are using the watch where time calibration signal reception is not possible
Manual Time Adjustment

Operation Guide