To connect with a newly purchased phone, you will need to perform the pairing operation again with the new phone. Use CASIO WATCH+ to delete the pairing information from your current (old) phone, and then pair the watch with the new phone.

Connection with the watch is not possible while the phone is in the Airplane Mode. After exiting the phone’s Airplane Mode, go to its Home Screen and tap the “CASIO WATCH+” icon. Then on the watch, hold down the CONNECT button (B) for about 1.5 seconds.

On the phone, disable and then re-enable Bluetooth, and then go to the Home Screen and tap the “CASIO WATCH+” icon. Next, on the watch, hold down the CONNECT button (B) for about 1.5 seconds.

Turn on the phone and tap the CASIO WATCH+ icon. Then on the watch, hold down the CONNECT button (B) for about 1.5 seconds.

Clear pairing information from the watch you are currently using, and then pair with another phone.

The phone will emit a tone when a connection is established with the watch, which takes a few seconds.

Since communication is performed using radio waves, the watch may not be able to find the phone even if it is within two meters. Certain environments may make the allowable communication range very short.

The watch will connect with the phone and perform auto time adjustment at around 5:00 a.m., 11:00 a.m., 5:00 p.m. and 11:00 p.m. The connection is automatically terminated after auto time adjustment is complete.

The phone’s time setting may not be correct.

①

Correct the phone’s time setting.

iPhone Users

• “Settings” “Privacy” Turn on “Location Services” “System Services” Turn on “Setting Time Zone”.

Android Users

• Refer to your phone’s user documentation.

②

Establish a connection between the watch and phone, and correct the time setting.

Auto Time Adjustment

The summer time start date and time, end date and time, or other rules were changed by authorities.

The Time zone hand will indicate the time zone to the right (+1 hour) of your World Time City’s time zone if summer time is being observed.

Button operations are disabled while high-speed hand movement is in progress after a watch setting is changed, etc. Wait until the hands stop moving before performing button operations.

Battery power is low. Keep the watch exposed to light until it recharges sufficiently.

The battery is dead. Keep the watch exposed to light until the battery recharges sufficiently.

This is due to one of the reasons below, and does not indicate malfunction. Simply wait until normal hand movement resumes.

• The watch is recovering from a power saving state.

• Establish a connection with the phone and correct the time setting.

The watch is in the charge recovery mode. Wait until the recovery process is complete (for about 15 minutes). The watch will recover more quickly if you place it in a brightly lit location.

Strong magnetism or impact may cause the hands of the watch to go out of alignment. Use CASIO WATCH+ to correct hand alignment.

The day is in the process of changing. For information about how the day changes, see the section below.

Leaving the crown pulled out for more than nine minutes without performing any operation will automatically disable crown operation. Push the crown back in to its normal position and then pull it out again.

Crown operation is disabled while high-speed hand movement is in progress after a watch setting is changed, etc. Wait until the hands stop moving before performing crown operations.

The watch stops operating whenever the battery goes dead. Keep the watch exposed to light until it recharges sufficiently.