Module No. 3578

Other Settings

This section explains other watch settings you can configure.

Changing the Date Display Format

  1. Enter the Timekeeping Mode.

    2. Navigating Between Modes

  2. Hold down (A) for at least two seconds. Release the button when the name of the currently selected Home City appears on the display.

    3. 3578_fl_HT_SET_comon

  3. Press (C) nine times.

    4. This displays a screen for selecting the date display format.

  4. Press (D) to select a date display format.

    5. [MM-DD]: Month, day

    [DD-MM]: Day, month

    3578_39_Other

  5. Press (A) to exit the setting screen.

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Enabling the Button Operation Tone

Use the procedure below to enable or disable the tone that sounds when you press a button.

  1. Enter the Timekeeping Mode.

    2. Navigating Between Modes

  2. Hold down (A) for at least two seconds. Release the button when the name of the currently selected Home City appears on the display.

    3. 3578_fl_HT_SET_comon

  3. Press (C) 10 times.

    4. This displays [KEY SOUND].

    3578_40_Other

  4. Press (D) to select [ON] or [OFF].

    5. [ON]: Operation tone enabled.

    [OFF]: Operation tone disabled.

    3578_41_fl_Other

  5. Press (A) to exit the setting screen.

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Note that alarm and timer tones still sound even while the operation tone is muted.

Resetting Watch Settings

This section explains how to return the watch settings below to their initial factory defaults.

Watch Settings

Stopwatch

Timer

Alarm

  1. Enter the Timekeeping Mode.

    2. Navigating Between Modes

  2. Hold down (A) for at least two seconds. Release the button when the name of the currently selected Home City appears on the display.

    3. 3578_fl_HT_SET_comon

  3. Press (C) twice.

    4. This causes the seconds to flash.

    3578_42_Other

  4. Hold down (B) for at least seven seconds. Release the button when [HOLD] disappears from the [SETTING CLEAR] / [HOLD] display.

    5. 3575_43_fl_Other

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Resetting the watch also deletes information for pairing the watch with a phone, and unpair them.

Back

Next