Module No. 3554

Enabling Auto Lap Timing

While auto lap timing is enabled, a lap is recorded each time you run the lap distance you specified.

Perform the required operations with the CASIO WATCHES phone app or on the watch to configure auto lap measurement settings.

You can set a lap measurement distance up to 10.0 km, in increments of 0.1 km.

To configure auto lap settings with the CASIO WATCHES phone app

Before using Auto Lap Timing, you need to use the CASIO WATCHES phone app to specify the Auto Lap Timing distance.

Check the connection

Make sure the BLE_mark symbol is shown on the watch display when you perform the procedure below. If BLE_mark is not displayed, refer to the information at the link below.

Connecting with a Phone Paired With the Watch

  1. phone-s Tap the “CASIO WATCHES” icon.

  2. phone-s Tap the “My Watch” tab.

  3. phone-s Select “GPR-H1000” and tap it.

  4. phone-s Select the setting you want to change and then perform the operation shown on the screen.

To configure auto lap settings with the watch

  1. Display the current time screen.

    2. Watch Mode

  2. Press (C).

    3. This enters the Activity Mode.

    Example:

    3554_ACTIVITY_Mode

  3. Use (A) and (D) to select an activity.

  4. Press (C).

    5. For activities that can be measured without receiving GPS signals, this operation returns to the measurement operation ready screen. In this case, advance to step 6.

    If you selected an activity that receives GPS signals for measurement, this operation starts the GPS signal receive operation.

  5. If you selected an activity that receives GPS signals for measurement, press (A) or (D).

    6. This displays the measurement operation ready screen.

  6. Hold down (A) for at least two seconds.

    7. This displays the activity measurement setting screen.

    3554_ACT_SET_set

  7. Use (A) and (D) to move the pointer to [AUTO LAP].

  8. Press (C).

  9. Use (A) and (D) to select [ON].

    10. To disable auto lap measurement, select [OFF].

    The currently selected setting is indicated by a check mark (icon_3475_Check_ALM) to the left.

  10. Press (C).

    11. This causes a cursor to appear, which you can use to set the auto lap measurement distance.

  11. Use (A) and (D) to specify the integer part of the distance value.

    12. 3554_097_ACT_SET

  12. Press (C).

    13. This moves the cursor to the decimal part of the distance value.

  13. Use (A) and (D) to specify the decimal part of the distance value.

    14. 3554_098_ACT_SET

  14. Press (C) to complete the setting operation.

    15. After the setting operation is complete, a check mark appears for a few seconds, and then the activity measurement setting screen re-appears.

  15. Press (E) to exit the setting screen.

Note

If GPS is being used for Auto Lap measurement, the Auto Lap measurement timing may be somewhat different from the distance setting.

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

Back

Next