Module No. 3554

Changing the GPS Receive Interval

Use the procedure below to specify the interval for receiving GPS signals and to acquire location information during activity measurement.

  1. Display the current time screen.

    2. Watch Mode

  2. Press (C).

    3. This enters the Activity Mode.

    Example:

    3554_ACTIVITY_Mode

  3. Use (A) and (D) to select an activity.

  4. Press (C).

    5. This displays the GPS signal receive start screen.

  5. Press (A) or (D).

    6. This displays the measurement operation ready screen.

  6. Hold down (A) for at least two seconds.

    7. This displays the activity measurement setting screen.

    3554_ACT_SET_set

  7. Use (A) and (D) to move the pointer to [GPS TRACKING].

  8. Press (C).

  9. Use (A) and (D) to move the pointer to [GPS].

  10. Press (C).

  11. Use (A) and (D) to select a GPS receive interval.

    12. [HIGH]

    Receive interval: Every second
    Positioning accuracy: High

    [NORMAL]

    Receive interval: Every second
    Positioning accuracy: Lower than [HIGH]

    [LONG]

    Receive interval: Every minute

    [OFF]

    GPS not used.

  12. Press (C) to complete the setting operation.

    13. After the setting operation is complete, a check mark appears for a few seconds, and then the GPS setting screen re-appears.

  13. Press (E) twice to exit the setting screen.

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

You can also change the GPS receive interval using the CASIO WATCHES phone app.

With BIKING or OPEN WATER SWIMMING, distance traveled is not displayed in the measurement results when the GPS reception interval is [LONG] or [OFF].

Back

Next