Module No. 3515
Configuring Training Alert Settings
You can use the CASIO WATCHES phone app to specify target alert intervals to inform you of your calories burned, elapsed time, distance traveled, and altitude climbed during training. Every time an alert target value is reached during activity measurement, a sound or vibration operation is performed, and an alert screen appears to notify you.
You can use a single watch operation to toggle all the alerts you configured with the CASIO WATCHES phone app between on and off.
To specify training alert target values with the CASIO WATCHES phone app
Important!
Note that you cannot specify alert target values using watch operations. Use the CASIO WATCHES phone app to configure settings.
Check the connection
Make sure the symbol is shown on the watch display when you perform the procedure below. If is not displayed, refer to the information at the link below.
-
Tap the “CASIO WATCHES” icon.
-
Tap the “My Watch” tab.
-
Select “GBD-H2000” and tap it.
-
Select the setting you want to change and then perform the operation shown on the screen.
To enable training alert with the watch
-
Display the current time screen.
-
Press (C).
-
Use (A) and (D) to select an activity.
-
Press (C).
-
If you selected an activity that receives GPS signals for measurement, press (A) or (D).
-
Hold down (A) for at least two seconds.
-
Use (A) and (D) to move the pointer to [TRAINING ALERT].
-
Press (C).
-
Use (A) and (D) to move the pointer to [ON].
-
Press (C) to complete the setting operation.
-
Press (E) to exit the setting screen.
This enters the Activity Mode.
Example:
For activities that can be measured without receiving GPS signals, this operation returns to the measurement operation ready screen. In this case, advance to step 6.
If you selected an activity that receives GPS signals for measurement, this operation displays the GPS signal reception start screen.
This displays the measurement operation ready screen.
This displays the activity measurement setting screen.
If you want to disable training alerts, move the pointer to [OFF].
After the setting operation is complete, a check mark appears for a few seconds, and then the activity measurement setting screen re-appears.
Important!
Use the CASIO WATCHES phone app to specify an alert target value for each item. You cannot use watch operations to configure alert target value settings.
Note
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.