Module No. 3515

Configuring Distance Measurement Settings

You can select measurement of either linear distance (straight-line distance) or surface distance (actual distance).

Surface distance measurements are calculated by taking horizontal travel as well as vertical movement into consideration.

  1. Display the current time screen.

  2. Press (C).

  3. This enters the Activity Mode.

    Example:

    3515_ACTIVITY_Mode
  4. Use (A) and (D) to select an activity.

  5. Press (C).

  6. This displays the GPS signal receive start screen.

  7. Press (A) or (D).

  8. This displays the measurement operation ready screen.

  9. Hold down (A) for at least two seconds.

  10. This displays the activity measurement setting screen.

    3515_ACT_SET_set
  11. Use (A) and (D) to move the pointer to [GPS TRACKING].

  12. Press (C).

  13. Use (A) and (D) to move the pointer to [3D DISTANCE].

  14. Press (C).

  15. Use (A) and (D) to select a setting.

  16. [ON]

    Surface distance measurement

    [OFF]

    Linear distance measurement

  17. Press (C) to complete the setting operation.

  18. After the setting operation is complete, a check mark appears for a few seconds, and then the GPS setting screen re-appears.

  19. Press (E) to exit the setting screen.

Note

While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.

You can also use the CASIO WATCHES phone app to change the distance measurement type.

Back

Next