Module No. 3506

Viewing the Face in the Dark

The watch has a light that illuminates the face for viewing in the dark.

To illuminate the face manually

Press (E) to turn on illumination.

Illumination will turn off automatically if an alarm starts to sound.

3506_14_LT_Info

Using Auto Light

If Auto Light is enabled, face illumination will turn on automatically whenever the watch is positioned at an angle of 40 degrees or more.

Light_a

Important!

Auto Light may not operate properly when the watch is at a horizontal angle of 15 degrees or greater from horizontal as shown in the illustration below.

Light_b

Electro-static charge or magnetism can interfere with proper auto light operation. If this happens, try lowering your arm and then angle it towards your face again.

When moving the watch you may note a slight rattling sound. This is due to operation of the auto light switch, which determines the current orientation of the watch. It does not indicate malfunction.

Note

Auto Light is disabled when any one of the conditions below exists.

While an alarm sound, timer sound, and/or vibration operation is in progress

If you do not disable it manually, Auto Light remains enabled for approximately six hours. After that, it becomes disabled automatically.

Configuring the Auto Light Setting

  1. Enter the Timekeeping Mode.

  2. Hold down (A) for at least two seconds.

  3. This displays the Timekeeping Mode setting screen.

    3506_set_disp_caps
  4. Use (A) and (C) to move the pointer to [LIGHT].

  5. Press (B).

  6. Use (A) and (C) to move the pointer to [AUTO LIGHT].

  7. Press (B).

  8. Use (A) and (C) to move the pointer to [OFF] (disabled) or [ON] (enabled).

  9. The [LT] indicator is displayed in the Timekeeping Mode while Auto Light is enabled.

  10. Press (B) to complete the setting operation.

  11. After the setting operation is complete, [SETTING COMPLETED] will appear for a few seconds, and then the illumination setting screen will re-appear.

  12. Press (D) twice to exit the setting screen.

Specifying the Illumination Duration

You can select either 1.5 seconds or three seconds as the illumination duration.

  1. Enter the Timekeeping Mode.

  2. Hold down (A) for at least two seconds.

  3. This displays the Timekeeping Mode setting screen.

    3506_set_disp_caps
  4. Use (A) and (C) to move the pointer to [LIGHT].

  5. Press (B).

  6. Use (A) and (C) to move the pointer to [DURATION].

  7. Press (B).

  8. Use (A) and (C) to select an illumination duration.

  9. [1.5 SEC.]

    1.5-second illumination

    [3.0 SEC.]

    3-second illumination

  10. Press (B) to complete the setting operation.

  11. After the setting operation is complete, [SETTING COMPLETED] will appear for a few seconds, and then the illumination setting screen will re-appear.

  12. Press (D) twice to exit the setting screen.

Back

Next