Module No. 3506

Enabling the Button Operation Tone

Use the procedure below to enable or disable the tone that sounds when you press a button.

  1. Enter the Timekeeping Mode.

  2. Hold down (A) for at least two seconds.

  3. This displays the Timekeeping Mode setting screen.

    3506_set_disp_caps
  4. Use (A) and (C) to move the pointer to [BEEP].

  5. Press (B).

  6. Use (A) and (C) to move the pointer to [OPERATION].

  7. Press (B).

  8. Use (A) and (C) to move the pointer to [ON] (enabled) or [OFF] (disabled).

  9. Press (B) to complete the setting operation.

  10. After the setting operation is complete, [SETTING COMPLETED] will appear for a few seconds, and then the BEEP (sound) setting screen will re-appear.

    3452_mute is displayed in the Timekeeping Mode while the operation tone is disabled.

  11. Press (D) twice to exit the setting screen.

Back

Next