Skip to content

CASIO

User´s Guide

Find

Creating a Numerical Table from Two Functions (TABLE)

TABLE generates a numerical table based on one or two functions. You can use the function f(x) or the two functions f(x) and g(x). See "Configuring the Calculator Setup" for more information.
Perform the following steps to generate a numerical table.


1. Press (TABLE) to enter the TABLE Mode.

2. Use the X variable to input two functions, one in the format f(x) and the other in the format g(x).

Be sure to input the X variable ((X)) when generating a numerical table. Any variable other than X is handled as a constant.

If you are using a single function, input a function in the format f(x) only.

The following cannot be used in the function: Pol, Rec.

3. In response to the prompts that appear, input the values you want to use, pressing after each one.

For this prompt: Input this:
Start? Input the lower limit of X (Default = 1).
End? Input the upper limit of X (Default = 5).
Note: Make sure that the End value is always greater than the Start value.
Step? Input the increment step (Default = 1).
Note: The Step specifies by how much the Start value should be sequentially incremented as the numerical table is generated. If you specify Start = 1 and Step = 1, X sequentially will be assigned the values 1, 2, 3, 4, and so on to generate the numerical table until the End value is reached.

Inputting the Step value and pressing generates and displays the numerical table in accordance with the parameters you specified.

Pressing while the numerical table screen is displayed will return to the function input screen in step 2.


Example: To generate a numerical table for the functions f(x) = x2 + 12  and g(x) = x2 - 12  for the range -1 ≦ x ≦ 1, incremented in steps of 0.5  (MthIO-MathO)

  • (TABLE)
  • (SETUP)(TABLE)(f(x),g(x))
    (X)12

Pressing without inputting anything for g(x) will generate a numerical table based on f(x) only.


  • (X)12
  • 1105

Note

You can use the numerical table screen for viewing values only. Table contents cannot be edited.

The numerical table generation operation causes the contents of variable X to be changed.

The maximum number of rows in the generated numerical table depends on the setup menu table setting. Up to 30 rows are supported for the "f(x)" setting, while 20 rows are supported for the "f(x),g(x)" setting.


Important!

The function you input for numerical table generation is deleted whenever you display the setup menu in the TABLE Mode and switch between Natural Display and Linear Display.

print this page
Top of page