Module No. 5692

If the stopwatch is reset to all zeros, performing the operation below in the Timekeeping Mode immediately starts a stopwatch elapsed time measurement operation.

1. In the Timekeeping Mode, press (D).

This enters the Stopwatch Mode.

What happens when you perform the above step depends on the current status of the stopwatch timing operation as described below.

Measuring Elapsed Time

When the stopwatch is reset to all zeros
A new elapsed time measurement operation will start. (One Press Start from the Timekeeping Mode)

When a previous measurement operation is paused
The measurement operation remains paused and does not restart.

When an ongoing measurement is in progress*
The measurement operation will continue.

An ongoing elapsed time operation continues even if you switch from the Stopwatch Mode to another mode.