Module No. 5672

Manual Time Calibration Signal Receive

  1. Place the watch near a window or some other location appropriate for time signal reception.

  2. Enter the Timekeeping Mode.

  3. Hold down (D) for at least 0.5 seconds until the second hand points to [RC].

  4. This indicates that the receive operation has started. After the receive operation is complete, the watch’s time and day settings will be adjusted accordingly.

    5672_RCmark_TM

Note

The receive operation takes anywhere from about two minutes to about 10 minutes. It can take as long as 20 minutes.

Time calibration signal reception is better at night than during the day.

A time calibration signal cannot be received while the watch is paired with a phone.

Back

Next