Configuring Stopwatch Settings
You can use the CASIO WATCHES phone app to configure the lap time measurement function settings shown below.
Specifying the Target Time Type
You can specify one of the target time types described below, which are used to calculate the difference between your target time and actual lap time measurements.
FASTEST:
Following start of a stopwatch elapsed time measurement session, the fastest measured lap time of the current session is automatically set as the target time. Resetting the stopwatch to all zeros will clear this target time.
TARGET:
You can use CASIO WATCHES to specify a desired target time.
LAST:
Following start of a stopwatch elapsed time measurement session, the last measured time of the current session is automatically set as the target time. Resetting the stopwatch to all zeros clear this target time.
-
1.
Tap the “CASIO WATCHES” icon. -
2.
Hold down (C) for at least 1.5 seconds until [CONNECT] starts to flash. -
When a connection is established between the watch and phone, [CONNECT] will stop flashing and the second hand will move from [R] to
.- If connection fails for some reason, [ERR] will appear on the display momentarily and then the watch will return to the mode it was in before you started the connection procedure.
-
3.
Perform the operation shown on the phone screen to specify a target time type.
Configuring TARGET Time Settings
If you specified TARGET as the target time type, perform the procedure below to specify the target time.
- The TARGET time value must be 30 seconds or greater.
-
1.
Tap the “CASIO WATCHES” icon. -
2.
Hold down (C) for at least 1.5 seconds until [CONNECT] starts to flash. -
When a connection is established between the watch and phone, [CONNECT] will stop flashing and the second hand will move from [R] to
.- If connection fails for some reason, [ERR] will appear on the display momentarily and then the watch will return to the mode it was in before you started the connection procedure.
-
3.
Perform the operation shown on the phone screen to specify the TARGET time.
Enabling or Disabling Alert Sounds
You can configure a setting so the watch beeps when the lap time reaches the target time during measurement.
-
1.
Tap the “CASIO WATCHES” icon. -
2.
Hold down (C) for at least 1.5 seconds until [CONNECT] starts to flash. -
When a connection is established between the watch and phone, [CONNECT] will stop flashing and the second hand will move from [R] to
.- If connection fails for some reason, [ERR] will appear on the display momentarily and then the watch will return to the mode it was in before you started the connection procedure.
-
3.
Perform the operation shown on the phone screen to enable or disable the alert sound.
Specifying the Measurement Interval Distance
You can specify a measurement interval distance, which will cause the average speed of the lap being timed to be indicated by the mode hand of the watch.
- The initial default setting of the measurement interval distance is 1 km (or 1 mile).
-
1.
Tap the “CASIO WATCHES” icon. -
2.
Hold down (C) for at least 1.5 seconds until [CONNECT] starts to flash. -
When a connection is established between the watch and phone, [CONNECT] will stop flashing and the second hand will move from [R] to
.- If connection fails for some reason, [ERR] will appear on the display momentarily and then the watch will return to the mode it was in before you started the connection procedure.
-
3.
Perform the operation shown on the phone screen to specify the measurement interval distance.
Top of page