Module No. 3567

Configuring Settings for Programmable Timers

If a timer countdown operation is in progress, reset the timer to its current start time before performing this operation.

Using the Timer

  1. Enter the Timer Mode.

    2. Navigating Between Modes

  2. Hold down (A) for at least two seconds. Release the button when the number of auto repeats setting (01 to 20) starts to flash.

    3. 3567_55_TMR_comon

  3. Use (B) and (D) to specify the number of timer repeats (Auto Repeat).

  4. Press (C).

  5. Use (B) and (D) to specify the position of the timer in the sequence.

    6. To specify the first position, set [1].

    3567_61_TMR

  6. Press (C).

    7. This causes the minutes digits of Timer 1 to flash.

  7. Use (B) and (D) to change the timer minutes setting.

    8. 3567_62_TMR

  8. Press (C).

    9. This causes the seconds digits of Timer 1 to flash.

  9. Use (B) and (D) to change the seconds setting.

    10. 3567_63_TMR

  10. Press (C) twice.

    11. This returns to the screen in step 5.

  11. Repeat steps 5 through 10 as many times as necessary to configure the settings of other timers.

  12. Press (A) to exit the setting screen.

Back

Next