Module No. 3567
Setting the Countdown Start Time
The start time can be set in 1-second units up to 60 minutes.
If a timer countdown operation is in progress, reset the timer to its current start time before performing this operation.
-
Enter the Timer Mode.
-
Hold down (A) for at least two seconds. Release the button when the number of auto repeats setting (01 to 20) starts to flash.
-
Use (B) and (D) to specify the number of timer repeats (Auto Repeat).
-
Press (C).
-
Use (B) and (D) to display [1].
-
Press (C).
-
Use (B) and (D) to change the timer minutes setting.
-
Press (C).
-
Use (B) and (D) to change the seconds setting.
-
Press (A) to complete the setting operation.


This causes the minutes digits to flash.

Holding down (B) or (D) scrolls through settings at high speed.
This causes the seconds digits to flash.

Note
While the setting is being configured, the watch will exit the setting operation automatically after about two or three minutes of non-operation.