Module No. 3564

Using the Watch in a Medical Facility or Aircraft

Whenever you are in a hospital, on an aircraft, or in any other location where connection with a phone may cause problems, you can perform the procedure below to disable auto time correction. To re-enable auto time correction, perform the same operation again.

  1. phone-s Tap the “CASIO WATCHES” icon.

  2. wat_s Hold down (C) for at least three seconds. Release the button when BLE_mark and [CNCT] start to flash.

    3. When a connection is established between the watch and phone, BLE_mark and [CNCT] will stop flashing and remain on the display.

    If connection fails for some reason, [ERR] will appear on the display momentarily and then the watch will return to the Timekeeping Mode.

    3564_fl_BLE_connect

  3. phone-s Perform the operation shown on the phone screen to enable or disable auto time correction.

Back

Next