Module No. 3554

Calibrating Barometric Pressure Readings

The watch’s pressure sensor is adjusted at the factory and normally does not require calibration. However, you can calibrate the displayed value if you notice major errors in readings.

Important!

The watch will not be able to produce correct barometric pressure readings if you make a mistake during the calibration procedure. Check to make sure that the value you use for calibration produces correct pressure readings.

  1. Display the current time screen.

    2. Watch Mode

  2. Use (A) and (D) to select [BAROMETER].

    3. 3554_BARO

  3. Press (C).

    4. This displays the current barometric pressure and temperature.

  4. Hold down (A) for at least two seconds.

    5. This displays the barometer/temperature measurement setting screen.

    3554_BAR_TEM_set_caps

  5. Use (A) and (D) to move the pointer to [BAROMETER CALIBRATION].

  6. Press (C).

  7. Use (A) and (D) to move the pointer to [MANUAL].

    8. Selecting [OFFSET OFF] returns barometric pressure calibration to its factory default state.

  8. Press (C).

    9. This displays the manual correction screen.

  9. Use (A) and (D) to input the current barometric pressure.

    10. 3554_073_BAR_TEM

  10. Press (C) to complete the setting operation.

    11. After the setting operation is complete, a check mark appears for a few seconds, and then the barometric pressure/temperature setting screen re-appears.

  11. Press (E) to exit the setting screen.

Back

Next